Microtest OMNIScanner LT Specifications download pdf (Page 47)

CHAPTER 3: Getting Started: Fiber Optic Networks

3.6 Running An Autotest for Fiber Optic Cabling

3.6.1 P

REPARING AN

UTOTEST

1. Connect OMNIFiber Main to the near end of the RX/TX fiber pair you are

testing and connect OMNIFiber Remote to the far end. Depending on the

method that was used to obtain the reference, connect your fibers as follows:

METHOD A

To run an Autotest when Method A was used to set the Reference proceed as

follows:

1. Do not disconnect the launch cables from the OMNIFiber Adapters.

2. Remove the connector adapters (sleeves) that connect the two launch cables.

3. Connect the OMNIFiber Main to one end of the duplex link under test, and

the OMNIFiber Remote to the opposite end.

850 nm

1300/1310 nm

850 nm

1300/1310 nm

2 m Launch Cable

Patch Panel

METHOD A

Wall Plate

Cable under Test

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 152 153

No comments

Microtest OMNIScanner LT Specifications Page 47