Microtest OMNIScanner2 User's Guide download pdf (Page 39)

3 - 5

OMNIScanner User Guide

The Adapter: field will automatically change to

reflect that OMNI

Fiber

is currently attached.

OMNI

Scanner

auto-senses the adapter. If the

adapter is changed, OMNI

Scanner

will automati-

cally adjust the content in the fields Autotest:

and Cable: to reflect the new setup.

Every Project has certain Autotests and cables

assigned already. These associated lists will

appear in the pop-up lists for each item. If the

Autotest or Cable you want to use is not in a pop-up list, open

(Setup) to select the appropriate item.

(See Chapter 4 - Setup: Autotest,

Cable, or Project for further information.)

Running an Autotest for Fiber Optic Cabling

Preparing an Autotest

1. Connect OMNI

Fiber

Main to the near end of the RX/TX fiber pair you are

testing and connect OMNI

Fiber

Remote to the far end. Depending on the

method that was used to obtain the reference, connect your fibers as

follows:

2 JUMPER METHOD AUTOTEST

To run an Autotest when the 2-Jumper Method was used to set the Refer-

ence proceed as follows:

1. Do not disconnect the launch cables from the OMNI

Fiber

2. Remove the connector sleeves that connect the two launch cables.

3. Connect the OMNI

Fiber

Main to one end of the duplex link under test,

and the OMNI

Fiber

Remote to the opposite end.

850 nm

1300/1310 nm

850 nm

1300/1310 nm

2 m Launch Cable

Patch Panel

Wall Plate

Cable under Test

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 132 133

Comments to this Manuals

No comments

Microtest OMNIScanner2 User's Guide Page 39

Comments to this Manuals

Related products and manuals for Cable network testers Microtest OMNIScanner2